1. QUESTION: How do I refill with water and how much?
ANSWER: The Dry Cell has a removable cap for easy refill. Just add your mixed electrolyte to the bubblier/reservoir you are using.
2. QUESTION: Will I still get the same power I have come to expect from my vehicle?
ANSWER: Yes. Adding HHO to the fuel system on an internal combustion engine, increases the combustion of the gasoline (or diesel). This can be compared to putting a super high grade of gasoline in your engine. You will get better overall performance, increased horsepower and gas mileage. You can expect 30-50% increase in gas mileage. It will all depend on the type of car, engine size and driving habits.
(Important Note) You must fool the computer on all vehicles that have fuel injectors. If you don't do this, you might see a couple MPG drop after the computer picks up the extra oxygen.
3. QUESTION: Is is difficult to install?
ANSWER: No, it is very Simple. All our cells and kits have complete detailed installation instructions located on our members web site. Along with our installation video. The procedure is pretty straight forward and we have good pictures, so it should not take longer than a few of hours.
4. QUESTION: Where should the Dry Cell be installed?
ANSWER: Anywhere in the engine compartment that is lower then the bubblier/reservoir you will be using, but preferably in a place where it will have a constant airflow (like in front of the radiator).
5. QUESTION: What happens if my Dry Cell runs dry?
ANSWER: Your dry cell can be damaged if ran for a long period of time dry. The easiest way to prevent this is to keep a gallon of mix in your vehicle and simply top off reservoir when refueling.
6. QUESTION: Do I need a PWM for your system?
ANSWER: No you don't need a Pulse Width Modulator (PWM) for our system. Purchasing one is just an added expense that you do not need. We control our amperage by our mix and can be viewed any time through your amp gauge.
7. QUESTION: If I run my car with the Dry Cell, will I get rust or corrosion in my engine?
ANSWER: No. The fossil fuel (gas or diesel) produces more than enough hit during combustion that when the HHO burns and converts back to water, the engine temps are high enough to keep it as a vapored steam until it exits the exhaust.
8. QUESTION: What happens if my water turns brown?
ANSWER: Simply flush unit with bleach water solution. This should not occur but every six months or so. When water is brown it is simply used KOH. If you have your cell circulating well this will not occur.
9.QUESTION: Do I need to turn the unit off when not in use?
ANSWER: No. If you have followed our manual, then your unit should be connected to the ignition switch so, every time you turn the engine off, the unit will turn off with it.
10. QUESTION: How do I service/clean my dry cell?
ANSWER: Its very simple just flush unit once every six months with bleach water solution.
Did not find the answer your looking for? Just shoot us an email :-)
FREE LIFETIME MEMBERSHIP WITH $85 PURCHASE!
Join Our Hydrogen Car Club And Let Us Help Convert
Your Car Into A Water/Gas Hybrid Today
